Engine turns but dont start"

What was the fuel pressure spec? Check for applicable mil codes. Maybe a timing issue?

Lbs out the fuel lines are 40 and 12Lbs out of the injecters..retimed the engine and now comes closer to starting but sputters a few times then stalls..once in a while it will sneas out the intake....but also the fuel safty switch relay keeps clicking...what do you sajest

Were there any mil codes? You may need to check compression? Which relay is clicking?

all the relays are good in the car.

To check for possible mil codes, you turn the key just till the dash lites come on,no further. Cycle the key on--off, on--off, on, then the mil starts flashing on the dash, you count the flashes to get the codes. Your looking for two digit codes. Example, a code 23 would be 2 quick flashes followed by a slight pause then three quick flashes.

If one of the relays in the diagram is clicking, If you click on the diagram, the picture will enlarge. I just wondered which one it was. If you put your finger on the relay, you should feel the vibration if clicking.