i can put it in drive and it just hums and wont change gear.what could be the problem?
Mar 5, 2012 at 4:36 PM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
JACOBANDNICKOLAS
CAR REPAIR CONTRIBUTOR
110,190 POSTS
If the check engine light is on, have the computer scanned. Also, make sure the trans fluid is clean and full.
Mar 5, 2012 at 4:42 PM
Advertisement
BARBARA1963
MEMBER
99 POSTS
put a new p sensor,modular has air,valves are not stuck,no check engine light,i did find a little metal stuck on the magnet on the p sensor,put the computer to scan,nothing.