I have just rebuild the motor an got it back in.

Tiny
ANONYMOUS
  • MEMBER
  • 1993 NISSAN HARDBODY
  • 204,000 MILES
I have just rebuild the motor an got it back in the truck and everything hooked up and I have no fire ive replaced the coil nd the ignition module and still no fire I have power to the plug that plugs to the module but nothin comin out of the coil ive tested the coil wire with a spark plug tester and theres no fire an ive also tested the ecm under the pass. Seat and the lights on it they both flash once then twice then 3 times them 4 then 5 and it starts all over and does it again so if anyone knoes anything please tell me cuz I dont what it could be thanks
Wednesday, October 24th, 2012 AT 8:56 PM

2 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
The duration of the flashes makes a difference to the codes. Refer to diagram for how to read the codes.
Which engine do you have?
With or without distributor?
Was this
answer
helpful?
Yes
No
Thursday, October 25th, 2012 AT 4:21 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Sorry for missing out the diagram.
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
Thursday, October 25th, 2012 AT 4:22 PM

Please login or register to post a reply.

Related No Spark Content

Ignition Spark Check
GUIDE
Ignition Spark Check
An engine's ignition system is responsible for igniting the fuel-air mixture inside the combustion chamber and when the ignition process stops the engine will not run....