INLET HOSES ON DIESEL CLUBWAGON FOR BACKFLUSH

1993 Ford E-Series Van

Tiny

1980flh

February, 24, 2012 AT 10:23 PM

I have a 1993 Clubwagon with the 7.3 diesel. For routine maintenance, I want to back flush the cooling system using the Prestone flush kit. It seems as if there are two inlet and two outlet hoses on this model. The van does have rear heat & A/C. Does it have two inlet hoses? If so, would I have to use two flush tees? If not, which inlet hose should be fitted with the flush kit. Thanks much.

FOUND 134 RELATED QUESTIONS

Low Side Hose

1 ANSWER

A/c Hose

3 ANSWERS

1 Answer

Tiny

blackop555

February, 25, 2012 AT 1:14 AM

Inlet to what? Heater core, water pump? If you want to flush it I would disconnect each heater core separately and flush them. Reattach, replace all coolant with water and some ford vc9 iron cleaner. Run vehicle get it hot. Then drain the system again plus the block refill and top off.

Please login or register to post a reply.

Air Conditioner Recharge - Simple
Cabin Air Filter Replacement Saturn Vue
Cabin Air Filter Replacement