truck starts, but won't go into gear?

1993 CHEVROLET SUBURBAN
2WD • AUTOMATIC
Avatar
CZR1760
  • MEMBER
  • 49 POSTS
I had a broken flywheel on my 93 Suburban. After installing a new flywheel, the truck starts, but won't go into gear. Please let me know what I may have done incorrectly on the re-install. Thanks.
Feb 22, 2011 at 2:02 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Hi,

If you replaced the flywheel, was everything bolted properly on the torque converter? Was the torque converter fully engaged into the transmission front pump? It is keyed into the pump. I attached a pic of where I'm referring to.

Let me know.

Joe

See pic below.
Image (Click to enlarge)
Attached Media
Sep 27, 2021 at 7:55 PM
Advertisement