Why does the starter get power, but will not crank the engine over

Tiny
BJLOSH88
  • MEMBER
  • 1991 MITSUBISHI ECLIPSE
  • 120,000 MILES
We were driving the car and it died, it would start then stall, after it was towed home, it wont crank. When you turn the key, you hear the starter engage, but it will not crank the motor. Starter has been replaced along with the relay, grounds seem good.
Thursday, February 9th, 2012 AT 3:59 PM

4 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
If its cranking over and will not start-Refer to this link:https://www.2carpros.com/articles/car-cranks-but-wont-start
Was this
answer
helpful?
Yes
No
Thursday, February 9th, 2012 AT 5:56 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Manually crank the engine to check if it has seized.

Ensure the battery is good, Try a jump start. You might have a failed alternator instead of a starer.
Was this
answer
helpful?
Yes
No
Thursday, February 9th, 2012 AT 9:08 PM
Tiny
BJLOSH88
  • MEMBER
  • 2 POSTS
The motor tried to Crank once, since then it will not crank. Battery is good and a jump start does the same thing.
Was this
answer
helpful?
Yes
No
Thursday, February 9th, 2012 AT 9:40 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Check to see if the engine is seized. It could also be due to a bad idler bearing or compressor. If the engine seems seized, remove the accessory beltings and retry.
Was this
answer
helpful?
Yes
No
Thursday, February 9th, 2012 AT 10:07 PM

Please login or register to post a reply.

Sponsored links