SPONSORED LINKS

Center motor mount discontenuied now what

Tiny
H-2 CHARLIE
  • MEMBER
  • 1990 GEO STORM
  • 66,500 MILES
It has a lite bang but not under a hard load anyways the motor mount has ben discontenuied I have looked for interchageable ones butT no luck. The dounut rubber can be swapped for a engery STIFF STYLE one but it might be to ruff. ANY IDEAS?
Sunday, November 20th, 2011 AT 4:11 AM

3 Replies

Tiny
H-2 CHARLIE
  • MEMBER
  • 6 POSTS
Not real close but I think I might have to pull it to be sure it might be here.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, November 20th, 2011 AT 7:10 AM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
I ran into a similar problem bein a penny pincher I was thinkin after I got a used mount that id clean the old rubber out of the old mount and just fill with silicone and let cure till I needed it again. Musta been too much work at the time and I let it go.
Was this
answer
helpful?
Yes
No
Sunday, November 20th, 2011 AT 6:16 PM
Tiny
H-2 CHARLIE
  • MEMBER
  • 6 POSTS
Well after looking a found a rebuilder in the next town that does them in 1-3 hr and its only 25 for the frt dog bone and 35 for rhe rear these are the tq. Ones the sides are fine. MIGHTY MOUNTS IN Rosemead ca.
Was this
answer
helpful?
Yes
No
Sunday, December 11th, 2011 AT 1:21 AM

Please login or register to post a reply.

Related Mount Content

Engine Torque Mount Replacement
VIDEO
Engine Torque Mount Replacement
Instructional repair video
Engine Mount
GUIDE
Engine Mount
Engine mounts are designed to isolate the vehicle from vibrations and harmonics created by the engine. Designed by using two metal plates vulcanized together with a sizable...

Sponsored links