location of pcv valve, 1990 ford 5.0 crown victoria

1990 FORD CROWN VICTORIA
78,000 MILES
Avatar
IH GUY
  • MEMBER
  • 3 POSTS
I need to replace the pcv valve - where is it on a 1990 Ford, 5.0, crown victoria?
May 6, 2012 at 2:16 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
It should be on the valve cover
May 6, 2012 at 3:04 AM
Advertisement
Avatar
DJCL
  • CAR REPAIR CONTRIBUTOR
  • 767 POSTS
Its located on the back of the engine near the fire wall behind the intake plentom chamber there is a screen that you will want to replace to
May 6, 2012 at 6:21 AM
Avatar
IH GUY
  • MEMBER
  • 3 POSTS
Dear djcl,

many thanks for your input & assistance.
You mentioned a screen to replace - where is that screen located?

all the best,
ih guy
May 7, 2012 at 1:38 PM
Avatar
DJCL
  • CAR REPAIR CONTRIBUTOR
  • 767 POSTS
Under the valve in the rubber gromit you might need a pick to get it out
May 7, 2012 at 1:41 PM
Avatar
IH GUY
  • MEMBER
  • 3 POSTS
Dear djcl,

many thanks.

all the best,
-Marty
May 7, 2012 at 2:09 PM