Replaced brake master cylinder and went to bleed.

Tiny
GRAHAMSTER1212
  • 1988 FORD RANGER
  • 130,000 MILES

Replaced brake master cylinder and went to bleed brake lines and right rear will not bleed. Changed out wheel cylinder and shoes while that far in and still no bleed! Any idea where to go next?

Do you
have the same problem?
Yes
No
Sunday, January 6th, 2013 AT 5:59 AM

2 Replies

Tiny
JACOBANDNICKOLAS
  • EXPERT
  • 68,398 POSTS

Check for damage to the brake line, work back to see where pressure is lost. It is odd, but the proportioning valve may be bad. NOTE: I am assuming that you have pressure to the left rear.

Was this
answer
helpful?
Yes
No
Sunday, January 6th, 2013 AT 6:02 AM
Tiny
GRAHAMSTER1212
  • MEMBER

Yes, there is pressure. Cant see any damage to line but will go back through though. Next stop would be the brake line tee on top of differential housing. Agrivating. Thanks

Was this
answer
helpful?
Yes
No
Sunday, January 6th, 2013 AT 6:52 AM

Please login or register to post a reply.

Other Brake Master Cylinder Replace/Remove Questions