need distributor specs for pick-up and coil for 1988 dodge dakota 3.9 eng.auto trans.
Dec 18, 2010 at 9:21 PM
distributor specs
1988 DODGE DART
NAUGHTY MONKEY
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Hello,
I believe that distributor has a Hall Effect Switch not a Pickup.
Here are the specs.....
Distributor
The 3.9L engines use Chrysler Hall Effect distributors. The only adjustment for either system is initial ignition timing
IGNITION COIL RESISTANCE (OHMS)
Application Primary Secondary
Prestolite 1.34-1.55 9400-11,700 Echlin or Essex 1.34-1.55 9000-12,200 Diamond 1.34-1.55 15,000-19,000
Ohms resistance must be measured at 70-80°F (21-27°C).
I believe that distributor has a Hall Effect Switch not a Pickup.
Here are the specs.....
Distributor
The 3.9L engines use Chrysler Hall Effect distributors. The only adjustment for either system is initial ignition timing
IGNITION COIL RESISTANCE (OHMS)
Application Primary Secondary
Prestolite 1.34-1.55 9400-11,700 Echlin or Essex 1.34-1.55 9000-12,200 Diamond 1.34-1.55 15,000-19,000
Ohms resistance must be measured at 70-80°F (21-27°C).
Dec 18, 2010 at 9:37 PM