1986 Dodge 600 engine starting problems

KYSDAD07

MEMBER
1986 DODGE 600
2.5L
4 CYL
FWD
AUTOMATIC
142,767 MILES

So I had my dodge put in a shop to get the timing belt replaced, it got finished and ran great for one day. The next morning I got up to warm my car up, I turned the key and nothing happens, no clicking or fuel pump priming or nothing. So I changed the starter myself, also replaced the ignition switch and the ign relay and still nothing! I know the battery is good because I had taken it to advanced auto and had it tested so I don't know what to do and reallydont want to put it in the garage again BC the $300 bill for one days use. Please if anyone could offer some advice that would be greatly appreciated! Please feel free to message me here or email me at makiyahsdad@yahoo. Com thanks

Saturday, December 7th, 2013 AT 1:32 PM

2 Replies

CJ MEDEVAC

MECHANIC
11,004 POSTS

THINGS CAN HAPPEN FAST

YOU HAD THE BATTERY TESTED PRIOR TO THE CURRENT PROBLEM OR AFTER?

MAY NEED IT CHECKED AGAIN.......LOOK AT IT AND SEE IF IT IS THE SAME BATTERY YOU HAD PRIOR TO THE REPAIR (SEEN THAT TOO!)

IT COULD BE POSSIBLE YOU HAVE ANOTHER PROBLEM.......LIKE MAYBE YOU ATTEMPTED A "JUMP" AND ARCED THE CABLES?....SECURITY ISSUE?

OK..........DOWN TO WHAT I SEE THE MOST.....USUALLY, THIS IS THE PROBLEM WITH SYMPTOMS LIKE YOURS

READ "MY ANSWER" IN THIS LINK...I MADE A FEW PICS AT THE END

https://www.2carpros.com/questions/1996-chevrolet-tahoe-wont-start-sounds-dead-battery-jumpbox-get-same-reults

RETURN TO THIS THREAD BEARING A BIG OLE GRIN, LET US KNOW WHAT YOU FOUND

THE MEDIC

Image (Click to make bigger)

Was this

answer

helpful?

Yes

No

Saturday, December 7th, 2013 AT 3:42 PM

HMAC300

MECHANIC
48,601 POSTS

Check the fusible links i'e pointed out in pic they mayhave burnt up. They will runn off the starter or battery. See if they have power on both sides.

Image (Click to make bigger)