Transmission bellhousing

Tiny
SOUTHERNSHOCKER
  • MEMBER
  • 1979 FORD BRONCO
  • V8
  • 4WD
  • AUTOMATIC
  • 91,000 MILES
Is there a inspection plate on a c6 transmission bellhousing that can be removed to bolt the torque converter to the flywheel when I put my motor back in I looked earlier and didnt see anything that can be removed thnx. It a 79 ford bronco with 400 motor
Monday, February 21st, 2011 AT 5:19 AM

1 Reply

Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
This is to old for the data base, but normally there is a lower plate (bottom section of front of bell housing) of if this is a one piece housing, you will access the bolts from the starter housing.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Monday, February 21st, 2011 AT 11:18 AM

Please login or register to post a reply.

Related Transmission Torque Converter Content

How a Torque Converter Works
GUIDE
How a Torque Converter Works
The torque converter is designed to act as a fluid coupler that can engage and disengage with the increase and decrease of engine rpm. When the vehicle is not in motion...
VIEW MORE