putting my new transmission it's in just slightly sideways?

1979 CHEVROLET CHEYENNE
Avatar
CHEVYGUY3636
  • MEMBER
  • 1 POST
When I'm putting my new transmission up for the last bolts, it's in just slightly sideways, just enough that the electrical wire can't reach that's next to the shifter, how to I straighten it? New transmission for 350 engine
May 17, 2012 at 2:05 AM
Advertisement
Avatar
PROMECHANIC
  • CAR REPAIR CONTRIBUTOR
  • 536 POSTS
Use some type of dowels to put in all of the holes, then install the bolts one by one, but don't tighten them. After you get them all in, then tighten them a little at a time one by one until the tranny is snugged up to the engine.
May 17, 2012 at 2:25 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.