WHY IS MY CLUTCH PEDAL FROZE

  • Tiny
  • Gmanp
  • 1978 INTERNATIONAL TRUCK
  • 200,000 MILES

I just replaced the clutch and pressure plate on my 1978 s-series dump truck and am unable to push in the pedal I have checked and the linkage is free I checked through the inspection plate and both the bearing and arm are fre but will not depress the plate at all am I missing something

Do you
have the same problem?
Yes
No
Wednesday, May 30th, 2012 AT 7:12 AM

2 Replies

  • Tiny
  • Rasmataz
  • MEMBER

You need to open it back up and investigate-something is binding in there

Was this
answer
helpful?
Yes
No
Wednesday, May 30th, 2012 AT 7:37 AM
  • Tiny
  • KHLow2008
  • EXPERT
  • 41,981 POSTS

Check the slave cylinder pushrod to see if it is out of alignment causing the binding.

Was this
answer
helpful?
Yes
No
Wednesday, May 30th, 2012 AT 12:40 PM

Please login or register to post a reply.

Other Transmission Clutch Pedal Replace/Remove Questions