CHEVROLET S-10 ENGINE

How Do I Replacce The Serpentine Belt Im Not Sure Where The Idler Pulley Is Or How To Move It. The Clutch On The A/c Unit Went Out And Im...

I Got This Truck From A Friend And It Was Already Taken Apart. I Got It Fixed And Am Trying To Put It Back Together But I Cannot Figure Out...

The Truck Starts Fine. Except When I Run It For 10 Miles, Then Park It For An Hour Or Two, Then It Wont Start. When I Turn The Key, There...

Skipping And Backfireing When Going One Speed Changed Map Egr Vacuum Control Tbi Gasket I Can Unplug Map And Runs Good But Uses Alot Of Gas...

We Had To Rebuild A Blown Head Gasket On My Dads Truck. We Got A New Head From Salvage. Told Us That The Cylinder Heads Were Interchangeble...

Hello, I Recently Pulled A Cylinder Head Off A Gm 262 V6 Engine. I Noticed That The Middle Cylinder Has An Exhaust Tract With Two Ports-...

4l60e In Limp Mode Second And Drive, No Low Or Overdrive. Is It Possible To Disconnect Comp. And Shift Manually?

Torque Specs. For Intake Manifold Bolts?

1988 S10 Blazer 4.3 Ltr V6 -- When Started, The Engine Runs Rough And Stalls. Will Do This Several Times Before It Starts And Runs...

How Do I Tell If I Have Blown A Head Gasket In My 1993 Chevy S10 Blazer?