1991 Chevy Lumina dies when put into gear

Tiny
DERSH
  • MEMBER
  • 1991 CHEVROLET LUMINA
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 113,000 MILES
Car starts ok but dies when put into gear have replaced ignition coil pack first thought the maf sensor but dont think so now thanks in advance for your help
Friday, September 25th, 2009 AT 1:59 PM

1 Reply

Tiny
DOUG RODRIGUES
  • MEMBER
  • 11 POSTS
Could be that it's dying when you step on the brake pedal. With the parking brake on, pull the large vacuum hose off the brake booster and plug the hose. Start the engine. Step on the brake and put the transmission in gear. Did it die? If it didn't die, reattach the vacuum hose to the brake booster and go through the steps again. If it does die it's probably a leaking brake booster. Of course it could be anything else too, but check this one first. Easy to do to rule it out as a problem.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Sunday, October 18th, 2009 AT 1:33 AM

Please login or register to post a reply.

Related Engine Stall While Driving Content

Code Read Retrieval/Clear Chevrolet
VIDEO
Code Read Retrieval/Clear Chevrolet
Instructional repair video
Engine Stalls While Driving
GUIDE
Engine Stalls While Driving
An engine that stalls while driving and then starts back up again, either immediately or after a short time is different from an engine that just wont start or if the...
VIEW MORE

Sponsored links