FORD FUSION ABS PROBLEM
2008 Ford Fusion • 75,000 miles
What would cause a brake line not bleed? i have had mastercylinder replaced because it wouldn't stop unless you pump the brakes. Then i was told it was my hydraulic pump in my ABS system, so i had it replaced (2) times. The tech has been working on it for 3 weeks can you give me some insight as to what the problem could be? there are 6 lines and only one of them isn't bleeding and the tech has been checking for blockage and leaks and hasn't found any as of yet.
October 23, 2012.
October 23, 2012.
a bad braske hose would do it.
3 times on module?? hope you are not using used parts, bad move
Thank you Roy for your prompt response. Would replacing a bad hose be expensive?
Thank you once again for your help!!!! Back to the Ford house i go to present this scenario to them. You have a fantastic day!
I have the brake warning light ON on the dash, and the ABS light does not work at all, even when I switch to ignite. I also have noticed that the ABS is not working in hard braking.
12 answers • 1999 Jeep Grand Cherokee • 161,000 miles
I have a 1999 jimmy 4.3L 4x4. I had all the brakes and rotors replaced 4 months ago and now the ABS light comes on and activates at low speeds. Father in law driving it and went to park...
2 answers • 1999 GMC Jimmy • 110,000 miles
1994 Honda Civic EX w/ABS.After replacing brake pads, MC (bench bled) and Booster, brake pedal has good steady pressure until the engine is started, then pedal goes to the floor.Brakes ...
4 answers • 1994 Honda Civic • 250,000 miles
My 1997 Olds Cutlass Suprme with 4 wheel disc brake has the ABS light glowing. It makes a clicking noise when the brake is applied when the ABS light is out. Then the light glows and ...
2 answers • 1997 Oldsmobile Cutlass • 146,800 miles