Radio getting no power. Any suggestions?

Tiny
JOSHUAPANCHISIN
  • MEMBER
  • 2003 NISSAN 350Z
  • 100 MILES
2003 350Z. Installing an aftermarket radio and it is not getting any power what so ever. Re-Checked the wiring which is correct and also checked the interior fuse panel radio fuse and it was fine. Any suggestions?
Thursday, August 9th, 2012 AT 1:04 PM

7 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Power is key on 12volts. I would re check fuses with a test light to confirm.

Roy
Was this
answer
helpful?
Yes
No
+1
Thursday, August 9th, 2012 AT 1:10 PM
Tiny
JOSHUAPANCHISIN
  • MEMBER
  • 4 POSTS
How many fuses is there that powers the radio? I checked the one on the interior fuse panel, but is there one in the fuse panel under the hood?
Was this
answer
helpful?
Yes
No
Thursday, August 9th, 2012 AT 1:15 PM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check if the radio unit has a blown fuse-make sure the wiring connector is attached properly
Was this
answer
helpful?
Yes
No
-1
Thursday, August 9th, 2012 AT 1:15 PM
Tiny
JOSHUAPANCHISIN
  • MEMBER
  • 4 POSTS
I checked the wiring over multiople times and it is done properly, and the fuse on the radio is fine. Is there something under the hood that I should be checking?
Was this
answer
helpful?
Yes
No
-1
Thursday, August 9th, 2012 AT 1:18 PM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check fuses below
Was this
answer
helpful?
Yes
No
Thursday, August 9th, 2012 AT 1:27 PM
Tiny
JOSHUAPANCHISIN
  • MEMBER
  • 4 POSTS
Thanks, I will give it a try
Was this
answer
helpful?
Yes
No
Thursday, August 9th, 2012 AT 1:37 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
At the radio connector, there must be 2 wires with battery voltage with ignition switch turned on, Light Green and Yellow.

With ignition switch off the Yellow wire should have battery voltage.
Was this
answer
helpful?
Yes
No
+1
Thursday, August 9th, 2012 AT 1:50 PM

Please login or register to post a reply.

Sponsored links