With a multi meter it should read about 800 ohms across the sensors terminals with it unplugged. When they test bad they usually read as a open let me know what you find.

Answered by saturntech9 (expert)
23,388 answers provided

what about the coil how do I test it, also where is the module? Thanks

Response from rio9760
2 questions asked

Did you check your crank shaft position sensor yet?That's going to be way more likely the module or both coils going bad at the same time.

Answered by saturntech9 (expert)
23,388 answers provided

Yes checked css it was good 750 ohms replaced it anyway. Next step will be to remove the modual? I will
keep in touch thanks

Response from rio9760
2 questions asked

Both coils were checked I tested them by reeplacing them one at and checking spark across the top with wires off, no spark coils good reinstalled original coils. Removed modual and installed a good used one. Car startes right up.

Response from rio9760
2 questions asked

Had a feeling it was the module I have never seen both coils fail at the same time glad to hear you got it fixed.

Answered by saturntech9 (expert)
23,388 answers provided