the throwout bearing just goes into the ears on the fork.

did you remove the fork??

Roy

Answered by ASEMaster6371 (expert)
24,854 answers provided

yes replaced clutch now throw out and fork not going together right

Response from perryfrey
1 question asked

when i push the clutch pedal the slave pushes all the way out

Response from perryfrey
1 question asked

did you snap in the throwout bearing into the pressure plate??

Roy

Answered by ASEMaster6371 (expert)
24,854 answers provided

does the throwout bearing need to snap into snap on fingers ?

Response from perryfrey
1 question asked

i put throwout on fork and not pressure plate

Response from perryfrey
1 question asked

not the fingers, the pressure plate.
if the slave is fully extended, it may have already seated. can you shift into gear with it running??

did you adjust the rod on the clutch master??

Roy

Answered by ASEMaster6371 (expert)
24,854 answers provided

no how do you do that?

Response from perryfrey
1 question asked

under the dash at the clutch pedal. you need a 12mm open end wrench to loosen the nut and turn the rod.

Roy

Answered by ASEMaster6371 (expert)
24,854 answers provided