1996 Honda Accord drivetrain

Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Again did the right axle back out from the seal?I can't see what you see. It could be a bad axle seal or cracked transmission case.
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 6:15 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
Yes it back out from the seal
after I put it back I turn the left wheel it get hard to turn at first after when it get loose the left axle back out like 1/8 inch
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 8:19 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Sounds like something is up with the new axle. Do you still have the old axle?Why did you replace the old axle?
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 8:58 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
Yea I still have the old axle.
I replaced because the inner boot was leaking grease
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 9:01 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Try putting the old axle back in and if nothing happens you know its the new axle.
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 9:13 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
Ok I will do that and check if the new axle looks the same thnt the old one I should did it
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 9:21 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Alright sounds good.
Was this
answer
helpful?
Yes
No
Sunday, September 8th, 2013 AT 9:37 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
What is the proper way to install cv axle in the transmission do I need to slightly hammer it or.
Was this
answer
helpful?
Yes
No
Monday, September 9th, 2013 AT 7:07 AM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Never use a hammer just use the slack in the inner joint to kinda slide hammer it in
Was this
answer
helpful?
Yes
No
Monday, September 9th, 2013 AT 9:17 AM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
Hello again
I think I found the source of the noise.I took off the passenger side axle shaft. There is wear marks on the shaft that goes in the differential I put my finger inside the differential and there is a play so I think the differential bearing is bad :(

how can I replace this bearing?
Was this
answer
helpful?
Yes
No
Tuesday, September 10th, 2013 AT 1:22 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Your talking about inside the transmission correct?If so you would to remove the transmission split the transmission case open and change the bearing out.I would say its not your typical diyer repair.
Was this
answer
helpful?
Yes
No
Tuesday, September 10th, 2013 AT 2:55 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
Yes sir the passenger side bearing inside the transmission (differential)
do I need special tool to remove the bearing?
What s gonna happen if I drive the car with that bad bearing?
Was this
answer
helpful?
Yes
No
Tuesday, September 10th, 2013 AT 4:20 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Which engine do you have?Also have you ever removed a transmission on a front wheel drive car or taken apart one of those transmissions?
Was this
answer
helpful?
Yes
No
Tuesday, September 10th, 2013 AT 4:57 PM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
The engine is F22b2 2.2 liter 4 cylinder not VTEC
i never removed a transmission. And never take apart a transmission.
But I did engine overhaul for my previous car cylinder rings head gasket valve steam seals valve job.
Was this
answer
helpful?
Yes
No
Tuesday, September 10th, 2013 AT 5:29 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
A transmission is a lot more complex as far as taking apart and putting it back together. Also I would check the input shaft bearing just on the other side of the transmission case where the input shaft comes thru the case. As far As the diff bearing most are pressed off and on. Also to remove the transmission you will most likely need A engine support to remove the subframe to remove the transmission. Unless there is a cross bar under the transmission on that car.
Was this
answer
helpful?
Yes
No
Wednesday, September 11th, 2013 AT 6:24 PM

Please login or register to post a reply.

Sponsored links