SPONSORED LINKS

3

Tiny
GLENNDION
  • MEMBER
  • 1995 BUICK REGAL
  • 75 MILES
3.8L engine how to r&r a/c compressor clutch bearing
Sunday, September 23rd, 2012 AT 6:05 AM

5 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Book procedures requires the compressor to be removed, meaning the freon has to be discharged but if you are able to get the required space in engine compartment, you might not need to discharge.

After removal of the drive belt, disconnect the clutch wire, remove center bolt and clutch plate.
Remove snap ring you can take the pulley assy out to replace the bearing.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+3
Sunday, September 23rd, 2012 AT 9:03 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Refer to diagram
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
+3
Sunday, September 23rd, 2012 AT 9:04 AM
Tiny
GLENNDION
  • MEMBER
  • 2 POSTS
Job all done. Didn't have to remove compressor.
Thank's glenn
Was this
answer
helpful?
Yes
No
+4
Sunday, September 23rd, 2012 AT 10:21 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
You're welcome.
Was this
answer
helpful?
Yes
No
+1
Sunday, September 23rd, 2012 AT 10:34 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
You're welcome
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Sunday, September 23rd, 2012 AT 10:35 PM

Please login or register to post a reply.

Related Air Conditioner Compressor Clutch Content

VIEW MORE

Sponsored links