SPONSORED LINKS

Electrical problems

Tiny
LMARRUFO
  • MEMBER
  • 1965 CHEVROLET
  • V8
  • 2WD
  • AUTOMATIC
  • 200 MILES
1965 chevy c10 rear right side brake and signal not working and tail is dimmer than left
Monday, February 28th, 2011 AT 1:11 AM

3 Replies

Tiny
CARADIODOC
  • MECHANIC
  • 33,752 POSTS
Start by checking the ground wire for the right socket. If no problem is found, use an inexpensive digital voltmeter to measure the voltage on the side of the brass base of the bulb while just the running lights are on, and again with a helper when just the brakes are applied. Holler back with those numbers.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, February 28th, 2011 AT 8:43 AM
Tiny
DAVE'S BIG BACKYARD!
  • MECHANIC
  • 262 POSTS
It might need a new socket, sometimes they rot away.
Was this
answer
helpful?
Yes
No
Tuesday, August 30th, 2011 AT 7:28 PM
Tiny
CADIEMAN
  • MECHANIC
  • 3,544 POSTS
Check the voltage at the turn signal switch. It controls both of these.I agree with car about the possable bad ground.
Was this
answer
helpful?
Yes
No
Tuesday, August 30th, 2011 AT 7:51 PM

Please login or register to post a reply.

Related Turn Signal Not Working Content

Turn Signal Problems
GUIDE
Turn Signal Problems
Turn signals are intended to help inform surrounding drivers of the vehicle's intended change in direction. Although there are a few different causes for signal failure...
VIEW MORE

Sponsored links