SPONSORED LINKS

1991 Nissan 300ZX No Pressure in clutch

Tiny
MCIM81
  • MEMBER
  • 1991 NISSAN 300ZX
  • 6 CYL
  • 2WD
  • MANUAL
  • 107,000 MILES
I have a 91 300zx and just replaced the clutch master and slave cylinder and have been bleeding the lines for 2hr. Ran about a pint of fluid through and I still have no pressure. Any Ideas. PLEASE HELP.
Saturday, September 19th, 2009 AT 11:04 AM

2 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
If there's no leak anywhere -best recheck the clutch master cylinder could have an internal leak in it even if its new there's such thing as manufacturers defects
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, September 19th, 2009 AT 12:03 PM
Tiny
MCIM81
  • MEMBER
  • 3 POSTS
Thanks for the reply I will take back the master and try a new one.
Was this
answer
helpful?
Yes
No
Saturday, September 19th, 2009 AT 1:25 PM

Please login or register to post a reply.

Related Transmission Clutch Slave Cylinder Content

Throw out Bearing Replacement
GUIDE
Throw out Bearing Replacement
A throw out bearing is used to apply force against the clutch pressure plate to release the clutch and should be replaced as part of the normal clutch job. It is a good idea...
VIEW MORE

Sponsored links