Torque spec for camshaft bearing caps on 1G-FE needed?

2002 LEXUS IS 200
290,000 MILES • 2.0L • 6 CYL • 2WD • MANUAL
Avatar
BROKEN IS200
  • MEMBER
  • 1 POST
I have had to replace my valve stem seals in my IS200 and I'm now putting it back together, however i can't seem to find any torque specs for the camshaft bearing caps and was wondering if anyone could help me out.
Jan 8, 2023 at 10:34 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
BORIS K
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 836 POSTS
Hello,

The camshaft bearing caps for the 1G-FE engine should be tightened to 15Nm.
Keep in mind that the bearing caps are marked I for intake and E for exhaust camshaft
Always apply a light coating of clean engine oil before fitting the caps.

Hope this helps.

Cheers, Boris
Jan 9, 2023 at 1:37 AM