92 Tempo: Removing the Distributor

1992 ALL OTHER MAKES ALL OTHER MODELS
Avatar
FORDEXPLO
  • MEMBER
  • 4 POSTS
I'm trying to replace the distributor on my 92 Tempo GL, but the problem is I have no idea where the mounting screws are! Usually on my other cars, the mounting screws were in plain view, but it isn't so with the Tempo. Does anybody know where the mounting screws are located at? Or if it doesn't use mounting screws, does anybody know where the place of detachment is between the distirbutor and motor is? Thanks in advance.
Mar 12, 2006 at 8:32 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
FORDEXPLO
  • MEMBER
  • 4 POSTS
thank you very much for the reply. it is greatly appreciated. I have already taken out the one distributor hold-down bolt that was in the picture from the link. However, the distributor still won't budge.
Mar 12, 2006 at 4:31 PM
Avatar
PEPPERMRJ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 1,158 POSTS
They can get tight. Try tapping the key with the coil wire removed,
Mar 12, 2006 at 7:14 PM
Advertisement