SPONSORED LINKS

HAVING TROUBLE GETTING CAR OUT OF P AND INTO GEAR ONCE STARTED. FORD EDGE FWD 6CYL

  • Tiny
  • Chris Brook
  • 2007 Ford Edge
  • 60,000 miles

Not sure what is going on simply wont shift into drive. I can hear a click when I press the release lever but its not freeing up and shifting into R, N, D

SPONSORED LINKS
Do you
have the same problem?
Yes
No
Tuesday, April 24th, 2012 AT 12:11 PM

2 Replies

  • Tiny
  • mhpautos
  • Expert
  • 30,591 posts

The lock out solenoid is proberbly faulty, check your owners manual as it should have instructions for the manual over ride, if not re post and I will see if I can find it.

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, April 24th, 2012 AT 1:18 PM
  • Tiny
  • Chris Brook
  • Member

I wanted to say thank you that was exactly the problem and it was in the manual.(Page 243)Its says to make sure Brake lambs are working properly as that may be issue. But all in all it was an easy fix. Thankyou.

Was this
answer
helpful?
Yes
No
Tuesday, April 24th, 2012 AT 2:24 PM

Please login or register to post a reply.

Similar Questions

2000 Ford Escort Putting Transmission Into Gear

Transmission problem 2000 ford escort 4 cyl two wheel drive automatic 85000 miles I can not get the shifter to engage. I push th
Asked by jvai ·
7 ANSWERS

Replaced The Slave Cylinder And Now It Has ...

Replaced the slave recently there is good clutch pressure. But I have to force it into gear. When the clutch is pressed there is a slig
Asked by NoxiousPwner ·
11 ANSWERS

Cd4e Shifting 2-3 Slippling When Hot Tranny, ...

Hello, the problem ford escape 3.0 battery dead then slipping on the shifting form 2 3 gear. No dtc codes appears. Rebuilt with
Asked by prokudanov@mail.ru ·
3 ANSWERS

1997 Ford Ranger Changing Gears

Transmission problem 1997 ford ranger 4 cyl two wheel drive manual 117000 miles my 1997 truck won't allow me to change gears wit
Asked by robitron ·
3 ANSWERS