HOW DO YOU REPLACE THE DRIVERS POWER SEAT SWITCH...

  • Tiny
  • Anonymous
  • 2007 Buick Rendezvous
  • 85,000 miles

How do you replace the driver's power seat switch? How do you get to it?

Thursday, December 20th, 2012 AT 10:33 PM

1 Answer

  • Tiny
  • ASEMaster6371
  • Expert
  • 25,502 posts

Eat Switch Replacement - Power

Removal Procedure

Remove the outer trim panel from the front seat cushion.

Use a small flat-bladed tool to release the retainers which hold the power seat switch to the outer trim panel.

Remove the power seat switch from the outer trim panel.

Remove the power seat switch harness from the front seat support.

Disconnect the electrical connector from the power seat switch.
Remove the power seat switch.

Installation Procedure

Connect the electrical connector to the power seat switch.

Install the power seat switch to the outer trim panel, pressing the switch into place until fully seated.

Important: The power front seat switch harness must be in the proper position for the proper installation of the outer seat cushion trim panel.

Connect the power seat switch harness to the front seat support.
Install the outer trim panel to the front seat cushion.

Was this
answer
helpful?
Yes
No
Thursday, December 20th, 2012 AT 11:40 PM

Please login or register to post a reply.

Similar Questions