2006 Chrysler PT Cruiser Pcm

2006 CHRYSLER PT CRUISER
96,000 MILES • 2.4L • 4 CYL • FWD • AUTOMATIC
Avatar
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
in the pcm there is a gel my question is what is the purpose of it , how to remove it and do i need to replace it after repair
Oct 20, 2015 at 6:53 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
if the gel is in where connection from harness it's dielectric compound and you should put some in when pcm is replaced.
Oct 20, 2015 at 7:12 AM
Avatar
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
the gel is on the motherboard aka computer
Oct 20, 2015 at 7:08 PM
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
just leave it alone it's an insulator
Oct 21, 2015 at 6:28 AM
Avatar
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
but to repair the pcm i need to remove it so how can i do it
Oct 21, 2015 at 6:36 AM
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
no idea.
Oct 21, 2015 at 6:50 AM
Avatar
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
do not answer my questions anymore you are not helping me
Oct 21, 2015 at 7:47 PM
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
I know because ecm's must be rebuilt by a rebuilder because you have no way to reflash it after it's fixed. but you know everything
Oct 22, 2015 at 6:11 AM
Avatar
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
if i dont repair the Eprom i do not have to reflash it.each time i ask you a question you answer is TAKE IT TO A PROS you not helping at all
Oct 22, 2015 at 7:22 PM