BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
How hard is it to remove valve cover?
2006 CHRYSLER 300
I have a 2006 crysler 300 touring V- 6 making a noise from lifter how hard is it to remove valve cover and tighten I did that on my 1985 camaro and 1953 chevy pick up is there a big difference
have the same problem?
Wednesday, May 30th, 2012 AT 6:37 PM
Its not bad to remove the valve cover, just take off the upper intake manifold then its a normal job, check for broken/worn valvetrain parts
Wednesday, May 30th, 2012 AT 6:50 PM
to post a reply.
Related Cylinder Head Valve Cover Replace/Remove Content
Oil And Condensate In Air Filter
There Is Oil And Water Condensate Being Pulled Over Into The Air Filter Via The Pvc Valve Hose What Would Cause This
2006 Chrysler 300 Oil Change
I'm Usually Very Good At Maintaining My Own Vehicles But I'm Playing Hell Just Trying To Find The Oil Fiter. Where Is It On This Vehicle?...
2006 Chrysler 300
2006 Chrysler 300 6 Cyl Four Wheel Drive 48000 Miles I'll Like To Know What Is Egr Flow Sensor And The Knock Senson
Is There Any Way To Prime Oil Pump Without Taking It...
Is There Any Way To Prime Oil Pump Without Taking It Out On A 2006 3.5 Liter Engine
2000 Chrysler 300 Oil Pan
Dont Have The Room To Take Out My Oil Pan Where Did Go Wrong?
Ask a Car Question. It's Free!
Engine Oil Leak
Engine Oil Change and Filter Kia Forte
Engine Oil Change and Filter Toyota Tundra
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.