1. Remove glove compartment door
2. Remove Engine ECU
3. Remove air duct (motor cover)
4. Remove blower motor (disconnect electrical connector, remove 3 screws).
September, 22, 2011 AT 4:35 PM
Thankyou promechanic I cant seem to see how the duct comes off I only see 1 screw and removing it didnt seen to loosen the duct/cover at all what am I missing?
September, 22, 2011 AT 7:01 PM
Here is a pic from the factory service manual. This is how it says to remove it: Disconnect: -Control Link
-Wire Harness Clamps
Remove the screw
Release the claw and remove the air duct
September, 23, 2011 AT 12:36 AM
Thanks very much for your prompt answer looks like I can finally clean the mouse poop out of me heater cheers turbo60