How to replace ABS module

ANONYMOUS

MEMBER
2005 NISSAN QUEST
165,000 MILES

How to replace abs module

Wednesday, November 7th, 2012 AT 3:54 PM

1 Reply

HMAC300

MECHANIC
48,601 POSTS

Pretty much unbolt lines and disconnect electrical, unboltform car remove and reinstall then bleed entire brake system. You better get it scanned to see what is wrong though, may not be the abs unit.

Please login or register to post a reply.

Related ABS Module Replace/Remove Content

2004 Nissan Quest Disconnecting Electric From Abs...

Abs Module Is Stuck In On Position As A Result It Is Drawing On Battery Even When Van Is Not Running. Of Course This Has Resulted In Dead...

Asked by tadams93 ·

1 ANSWER

2004

NISSAN QUEST

VIDEO

ABS Module Replacement Video

Instructional repair video

GUIDE

ABS and Traction Control Module Replacement

The ABS control module is used to monitor the wheel rotational speed and will send a signal to the ABS valve and motor pump to decrease or increase the brake line pressure...

Front Rotor Repair

My Steering Wheel Is Shaking, Badly Whenever I Brake. Not My Brakes Are Starting To Squeak. I Really Can't Afford To Get Both Things Done...

Asked by canjones ·

7 ANSWERS

2006

NISSAN QUEST

Front Right Rotor Problem

Hey I Am Doing Front Rotors On A 1999 Nissan Quest Gxe And I Was Wondering If You Had To Take The Axle Nut Off When You Take Off The Front...

Asked by Johnathan henderson ·

1 ANSWER

1999

NISSAN QUEST

After Replacing Brakes Driver's Side Brake Will...

Replaced Driver Side Rotor Caliper Brake Hose And Pads. Bleed System But Brake On That Side Will Not Release.

Asked by oscarz ·

4 ANSWERS

1996

NISSAN QUEST

Vibration Front Wheel During Brake Apply Chaged...

Vibration Front Wheel During Brake Apply Chaged Rotor Pad & Amp; Abs Not Fix

Asked by gosh ·

3 ANSWERS

2001

NISSAN QUEST

Sponsored links

Ask a Car Question. It's Free!