I replaced a bad crankshaft in a 3.8 dodge motor, got it all put back together, the engine started right up and runs. No road test yet... after a short warm up I checked for any engine codes and got these: p0016- crankshaft / camshaft position bank-1 sensor-A correlation (camshaft crankshaft misalignment, p0344- camshaft position sensor- A high input bank- 1.
Could I have bolted the flywheel back up to the crankshaft incorrectly? If so is their any way to correct this without pulling the motor again??
Could I have bolted the flywheel back up to the crankshaft incorrectly? If so is their any way to correct this without pulling the motor again??
Sep 2, 2014 at 9:39 AM