2004 mazda 6 altenator

2004 MAZDA 6
4 CYL
Avatar
TERRYHURRICANE01
  • MEMBER
  • 1 POST
How do i change altenator on 2004 mazda 6?
Aug 2, 2011 at 7:15 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
JDL
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,098 POSTS
This is for 6i. Disconnect negative battery cable. Remove the under cover. Remove the right side splash shield. Turn the center of the tensioner pulley clockwise to release tension to the drive belt. Remove the drive belt. Remove the generator duct. Disconnect terminal B wire. Disconnect generator harness connector. Remove generator heat insulator. Remove generator. Install is the reverse of removal.
Aug 2, 2011 at 8:03 PM