Is it normal for my car to shift hard the first few miles after a tranny flush?
BIG_NATE1@LIVE.COM
MEMBER
2004 CHEVROLET IMPALA
90,017 MILES
I had been feeling a stutter when the car would shift into second gear so I went to have a flush and now after a couple miles of driving it is shifting hard into gears.
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Tuesday, December 6th, 2011 AT 10:37 PM
7 Replies
SATURNTECH9
EXPERT
No its not normal sounds like possibly a bad pressure control solenoid especially since it started after the flush. Any codes?Also what size engine do you have?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, December 6th, 2011 AT 10:45 PM
BIG_NATE1@LIVE.COM
MEMBER
Its a 3.4l v6 and not any codes that I know of. I dont know what I'm gonna do if it messed up my transmission. I just need an inexpensive solution.
Was this
answer
helpful?
Yes
No
Tuesday, December 6th, 2011 AT 11:06 PM
SATURNTECH9
EXPERT
Have you had it scanned for codes?If not have that done most auto parts do that for free. If you have any codes post the exact code numbers. Another thing that can cause hard shifting is a inlet air temp sensor issue.
Was this
answer
helpful?
Yes
No
Tuesday, December 6th, 2011 AT 11:18 PM
BIG_NATE1@LIVE.COM
MEMBER
I just went to have it scanned, no codes were found. It shifted hard the whole way there and on the way back it was fine. I have no idea whats going on.
Was this
answer
helpful?
Yes
No
Wednesday, December 7th, 2011 AT 12:06 AM
SATURNTECH9
EXPERT
I would have a complete pressure test done on the transmission thats where I would start.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, December 7th, 2011 AT 12:17 AM
BIG_NATE1@LIVE.COM
MEMBER
How much does that usually cost? Just so im not gettin ripped off.
Was this
answer
helpful?
Yes
No
Wednesday, December 7th, 2011 AT 12:20 AM
SATURNTECH9
EXPERT
About a hr shop labor rate also it needs to checked when its cold and acting up.