Replacing valve cover gaskets on 2002 Dodge Caravan SE

Tiny
DRAGONBABIES2000
  • MEMBER
  • 2002 DODGE CARAVAN
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 215,000 MILES
How do you replace the valve cover gaskets on a 2002 dodge caravan se? I was told that I should take off the intake manifold and wiper assemply is that correct? And do I need to replace any other parts or gaskets at the same time? Any advice would be greatly appreciated thanks.
Tuesday, April 5th, 2011 AT 3:46 AM

1 Reply

Tiny
CARADIODOC
  • MECHANIC
  • 34,330 POSTS
The intake plenum has to come off to remove the rear valve cover. You might be able to buy new gaskets but there aren't any in there now. They use liquid gasket sealer. The best sealer is Mopar silicone gasket sealer. There are two to pick from. The black stuff stays a little more rubbery and it absolutely will not bond and seal if there is any film of oil on either of the surfaces. They must be perfectly clean and dry.

The gray stuff gets harder and it will bond through a film of oil. It's still good practice to have both surfaces clean and dry. Don't get carried away with the tightness of the bolts. Hand tight with a small ratchet is sufficient.
Was this
answer
helpful?
Yes
No
-3
Tuesday, April 5th, 2011 AT 4:49 AM

Please login or register to post a reply.

Related Cylinder Head Valve Cover Gasket Replace/Remove Content

VIEW MORE