2002 Dodge Caravan p 0201 code

2002 DODGE CARAVAN
98,500 MILES
Avatar
JEREMYG
  • MEMBER
  • 2 POSTS
i have replaced the #1 fule injector ,spark plugs & wires & tps and repaired wires that were melted together on the fule injector wiring harnes and yet its stll gives me the same cod and it still dives ruff
Jul 5, 2013 at 3:56 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Are you getting power to the injector that was repaired? (checked it using a noid light)? If you remove the spark plug from the cylinder that had the problem, is it wet or dry? If dry, your injector isn't working. If wet, spark may be the problem.
Jul 5, 2013 at 6:53 PM
Avatar
JEREMYG
  • MEMBER
  • 2 POSTS
it was wet and when i changed the spark plug was burned up. i checked the spark comming off the coil and it looked pretty good.. ill be checking for power at the fule injector in the morring. thanks
Jul 5, 2013 at 7:04 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
When checking for power to the injector, make sure to use a noid light. If you use a test light, you won't know if the ground is good. However, if the plug was wet, it sounds like it is getting gas.

Here is a simple test that may be shocking if you aren't careful. When the engine is running, remove one spark plug wire at a time. When you get to the cylinder that is causing the miss, there will be no change when the plug wire is removed. All good cylinders will cause the engine to run worse or miss worse. The think is, use a good pair of insulated pliers to remove the plug wires so you don't get shocked.

If you do what I suggested, it should identify which cylinder is causing the miss. Just don't get shocked. It hurts. lol Once the troubled cylinder is identified, then you can check it for spark and for fuel getting to the cylinder.

Let me know if I can help.

Joe
Jul 5, 2013 at 7:19 PM