2002 Cadillac Escalade replace the EBCM

2002 CADILLAC ESCALADE
100,000 MILES • V8 • AWD • AUTOMATIC
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
2002 Cadillac Escalade that pulled up DTC C0286. The repair tech said that I should replace the EBCM. Where is it located on the vehicle? How do I reset the light once replaced? Are there any other solutions without replacing the EBCM?
Oct 21, 2010 at 4:13 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
That code refers to a specified amount of leak down in the pressure of the ABS. If the proper diagnostics was followed, and the results point to a bad EBCM then go for it. The EBCM is located on the inner frame rail, left side. Usually a scanner is required to clear ABS codes.
Oct 20, 2010 at 9:15 PM