i have code p0201

2001 DODGE RAM
120,000 MILES
Avatar
TOMMY 54
  • MEMBER
  • 3 POSTS
i put new injector checked wiring it is good
Jul 1, 2012 at 4:06 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
CARADIODOC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 34,308 POSTS
Chrysler has extremely little trouble with their injectors. If you suspect one, swap it with one from a different cylinder to see if the code follows it to that cylinder. For that code a more likely suspect would be a spread connector terminal at the injector, a corroded terminal in the computer's connector, or even a problem in the computer.
Jul 1, 2012 at 4:50 PM
Avatar
TOMMY 54
  • MEMBER
  • 3 POSTS
i switched injectors and it is still number one
Jul 1, 2012 at 4:54 PM
Advertisement
Avatar
CARADIODOC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 34,308 POSTS
You could use an ohm meter to test the continuity of the wiring from the computer's plug, and to see if the control wire is grounded, but a better test involves using a scanner to pulse that one injector, then listen for the clicking. You would also see a corresponding drop in fuel pressure if you had a pressure gauge installed.

Code 201 references injector number 1 but it goes further and can refer to a problem with any injector on that side of the engine.
Jul 1, 2012 at 6:37 PM