Can I get a ignition switch wiring diagram for a 01 impala?

2001 CHEVROLET IMPALA
150,000 MILES
Avatar
J.STIEG
  • MEMBER
  • 361 POSTS
Can I get a ignition switch wiring diagram for a 01 impala?
Oct 9, 2012 at 6:24 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
Having trouble with the starter not turning the car over?If so turn the key to the start position if there is power the switch is good. Check out the images (Below). Please let us know what happens.
Image (Click to enlarge)
Attached Media
Oct 9, 2012 at 6:57 PM
Avatar
J.STIEG
  • MEMBER
  • 361 POSTS
Its fine right now but, but the failer is intermittent. Might be having problem with the "run voltage" as well. I will be checking it later.

Post ignition switch diagram if you would. Thanks
Oct 9, 2012 at 9:05 PM
Advertisement
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
I will post the wire diagram in a little bit what i ment to say was the yellow wire from the ignition switch should have battery voltage when the key is in the start position.So the starter is inop when it wont start?Also does it happen more often when the engine is hot?Is the security light on solid or flashing when it wont start?
Oct 9, 2012 at 9:48 PM