How do I remove the bolt (NO room) so that I may replace my oil cooler hoses?

Tiny
NYCHRIS1
  • 2001 CHEVROLET BLAZER
  • 145,445 MILES

I am having A LOT of trouble removing the bolt, rear of engine block
in order to replace my cooler hoses (not tranny lines, not the oil hose to radiator, THE oil hose from oil filter housing to engine block.)
There is no room, you can see it through a VERY little space from the wheel well and a small opening between transfer case and drives haft.
PLEASE, PLEASE advise.

Thank You
Chris

Do you
have the same problem?
Yes
No
Tuesday, February 21st, 2012 AT 9:38 PM

1 Reply

Tiny
HMAC300
  • EXPERT
  • 46,428 POSTS

Try a 3/8 drive extension with a wobble type socket on it.

Was this
answer
helpful?
Yes
No
Tuesday, February 21st, 2012 AT 9:53 PM

Please login or register to post a reply.

Related Oil Cooler Hose Questions