BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Engine runs rough after changing motor mount
2001 CHEVROLET BLAZER
The motor mount broke on the driver's side and it started running bad. We had the motor mount replaced but it's still running rough. Any suggestions?
Monday, October 22nd, 2012 AT 10:30 PM
Motor mount has nothing to do with the motor issue
is there any codes>?
Have you changed your plugs, coils, wires recently?
Monday, October 22nd, 2012 AT 11:41 PM
to post a reply.
Related Mount Replace/Remove Content
1997 Chevy Blazer Motor Mount Replacement
Sir, Could You Provide Me The Best Or Proper Procedure Required To Replace Both Motor Mounts. I Have A Chilton Manual But Does Not Give A...
Engine Mount Replacement
Engine mounts are made of durable rubber which cushions the engine vibration from the vehicle frame. These mounts hold the engine in the car and are bolted to the engine...
Oxygen Sensor For A 2001 Blazer
I Just Bought An O2 Sensor For My 2001 Blazer With 111,000 Miles (4.3 L Engine) After Getting It Serviced. I Have No Clue Where To Put It...
No Power To Starter
I Have A 2001 Chevy Blazer 4.3. I Have 12 Volts Showing On The Volt Meter, Lights, Windows, Radio, All Fine, Just Not Getting Power To...
2001 Chevy Blazer Shutting Off Issue
It Will Start Fine, Run Smooth But After Maybe 10 Minutes It Will Shutdown, No Check Engine Light. After Aproximately 15 Minutes It Will...
2001 Chevy Blazer Tune-up
I Was Wondering Where The Spark Plugs Are Located On A 2001 Chevy Blazer? I Think They Are In A Box Because It Is A Vortec, But If So Where...
Ask a Car Question. It's Free!
Ignition Spark Check
Engine Oil Change and Filter Chevy Silverado
How to Tell Which Cylinder is Misfiring!
Help us make this site better
Online car repair manuals
Terms & Conditions
© 1999 - 2019 2CarPros, Inc.