Windshield washer pump

Tiny
RANDYST
  • MEMBER
  • 2000 OLDSMOBILE INTRIGUE
  • 6 CYL
  • 152,000 MILES
What is the best way to get to the windshield washer pump to replace it with a new one? I am replacing it on an Oldsmobile Intrigue.
Do you
have the same problem?
Yes
No
Thursday, December 30th, 2010 AT 12:19 AM

1 Reply

Tiny
SATURNTECH9
  • EXPERT
Here you go.
REMOVAL PROCEDURE

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the wheel.
3. Remove the inner fender liner.
4. Remove the connector and the hose from the washer pump
5. Remove the washer pump from the washer solvent container.

5.1. Pull top of the washer pump out from the side of the washer solvent container.
5.2. Remove the washer pump from the washer solvent container.

6. Remove the washer pump seal from the washer solvent container.

INSTALLATION PROCEDURE

1. Install the washer pump seal in the washer solvent container.
2. Install the washer pump in the washer solvent container.

2.1. Push the washer pump inlet into the washer solvent container completely.
2.2. Push the top of the washer pump into the side of the washer solvent container.

3. Install the hose and the connector to the washer pump.
4. Install the inner fender liner.
5. Install the wheel.
6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Was this
answer
helpful?
Yes
No
+2
Thursday, December 30th, 2010 AT 12:34 AM

Please login or register to post a reply.

Recommended Guides