How do I remove the ignition switch

2000 LEXUS ES 300
100,000 MILES
Avatar
DPEREZ
  • MEMBER
  • 1 POST
I am locksmith that clones keys. I do not remove ignitions or create a fist key. I had this new clone and it got stuck in the ignition. I forced it out. Then the original started having problems getting in and out. No problems turning. I have a locksmith friend that will fix the ignition if only I can take it to his shop. What are the steps to taking this ignition out. I was told by another locksmith that it is not easy. Will I ve to move or remove the stearing column.?
Dec 29, 2011 at 1:21 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
RIVERMIKERAT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 6,110 POSTS
STEERING COLUMNS -2000 Lexus ES 300
Page 1 of 1
Removal & Installation (ES300)

Disconnect negative battery cable. Remove steering column. See STEERING COLUMN . Unplug switch connector. Remove retaining screws and ignition switch. To install, reverse removal procedure.
Tighten mounting screws until screw heads break off.

Dec 29, 2011 at 1:31 AM