serpentine belt

1999 SATURN SL2
Avatar
GODDESSGRANDMA
  • MEMBER
  • 1 POST
tighten serpentine belt on 99-sl2 saturn
Nov 22, 2010 at 5:09 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
Uses a spring loaded belt tensioner no adjustment. if belt squeals or loose then tensioner is faulty
Nov 22, 2010 at 5:13 PM
Avatar
DR LOOT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 2,311 POSTS
Removal NOTE:Tools Required: J-39914 Drive Belt Tension Wrench. Disconnect the negative battery cable. Using the J-39914, rotate the belt tensioner. See Fig. 23. Remove the drive belt from the generator pulley. Support the engine by the oil pan. Remove the engine mount assembly from the engine mount bracket support. See Fig. 24. Remove the auxiliary bracket. Lower the engine in order to remove the drive belt. See Fig. 25. Remove the drive belt. Installation Using the J-39914, rotate the belt tensioner and install the drive belt. Install the auxiliary bracket. Install the auxiliary bracket fasteners. Tighten the fasteners to 37 ft. lbs. (50 N.m). Install the engine mount assembly to the engine mount bracket support bolts. Remove the floor jack. Connect the negative battery cable.
Images (Click to enlarge)
Attached Media
Attached Media
Attached Media
Attached Media
Attached Media
Nov 22, 2010 at 5:26 PM
Advertisement