BECOME A MEMBER
It is free to join!
I AGREE TO THE
BECOME A MEMBER
PROBLEM WITH GEAR CHANGE
1999 Mercedes Benz Vito
June, 10, 2012 AT 5:48 PM
My vito 115 manual 230e have problem with gear change at level 3. It sound noisy and difficult to change from gear t2 to 3 and from gear 4 back to 3
i have overhaul and change all my gear box bearing. But get difficulty to enter gear 3
FOUND 3059 RELATED QUESTIONS
Jerking In Any Gear When I Step On It
Can Gears On 92 V-6
June, 10, 2012 AT 6:26 PM
Did you check the 3rd gear synchronizer ring and hub?
June, 10, 2012 AT 6:35 PM
I have check all when overhaul that gearbox but not change cluth and cluth cover. The other gear was good. Is that any problem with my cluth pump
June, 10, 2012 AT 6:45 PM
If it is only the 3rd gear that is crashing while engaging, no, it is not due to the clutch.
That should be internal and the most lightly cause would be the 3rd gear synchronizer ring gear and hub.
to post a reply.
How To Change A Timing Gear On F150 300 6 ...
How to change a timing gear on a 1995 300 6 cylinder ford
Why Wont My Delta Integrale Engage Or Disingage...
136000 is km not miles it sometimes goes straight into gear and out wile switched off with clutch pressed or not but other times it gos
Car Has Plenty Of Power In Park But Not When Put...
The engine has all of it's power when it is in park and the throttle responds fine but the moment it is put into gear the engine has
Transmission Drain and Refill Kia Sportage
Ask a Car Question. It's Free!
Need To Service Your Automatic Transmission? Do It Like A Pro
Automatic Transmission Service
Transmission Service Toyota Tacoma
Transmission Fluid Replacement Mercedes Benz
Transmission Service Ford Super Duty F-250
Need To Replace Your Engine Flywheel? Do It Like A Pro
© 1999 - 2015 2CarPros, Inc.