BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
I recently changed ignition lock cylinder, and.
1999 FORD RANGER
I recently changed ignition lock cylinder, and car key needs to be programed, Is there any way to do it myself or bypass
Saturday, November 10th, 2012 AT 6:46 PM
No it has to be done by a dealer, if you would have had original key then you could have but since you've changed locks you need dealer to do it
Saturday, November 10th, 2012 AT 7:47 PM
to post a reply.
Related Ignition Switch Lock Content
1989 Ford Ranger Ignition Switch Lock Cylinder
I Lost My Ignition Keys. I Bought A New Cylinder And Keys But Cannot Figure Out How To Get The Old One Out. Is There A Trick To Use If You...
Ignition Lock Removal
Need To Replace Igntion Lock. Took Off Steering Column Covers, Looked For 1/8 Pin Hole To Pop Out Lock, Couldnt Find
Ignition Cylinder Lock Wont Remove Please Help
I Lost The Last Key To My 97 Ford Ranger. So I Drilled Through The Key Hole Like I Was Told But The Drill Bit Broke Off Inside. So I Drilled...
1994 Ford Ranger Ignition Lock
My Ignition Lock Needs To Be Replaced. How Do I Go About Doing This? Thanks! Deafrev In Fresno
1991 Ford Ranger Xlt 3.0. The Ignition Lock Apparently Broke Inside And Will Not Turn Either Way, So The Release Pin Cannot Be Pushed. How...
Ask a Car Question. It's Free!
Battery Cable Clean - Everything Goes Out
Code Read Retrieval/Clear Honda Civic
Find a car manual for your car
© 1999 - 2018 2CarPros, Inc.