1998 Eclipse 2.0 Slave Cylinder

GEARHEAD720

MEMBER
1998 MITSUBISHI ECLIPSE
4 CYL
FWD
MANUAL
130 MILES

I was replacing the slave cylinder on a 1998 2.0 N/A Eclipse when I went to slip the new slave in from autozone the bleeder was rubbing on the center subframe. If I tighten the bolts down to secure the slave the bleeder is pinned up against the frame. Does anyone have a part number? I went to autozone and they could not find nothing that matches to the oem slave I took off. The old slave bleeder was up top of the slave and the new for autozone is underneath next to the banjo. Thanks, SkyZero

4 Replies

SATURNTECH9

MECHANIC
30,870 POSTS

Anyway you can post a picture of your old slave cylinder?That would really help. Do you have a turbo or non turbo engine?

Was this

answer

helpful?

Yes

No

Saturday, January 8th, 2011 AT 7:31 PM

GEARHEAD720

MEMBER
3 POSTS

It's N/A Motor. I dont have it on hand but I will as soon as I can get ahold of the stock one.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Saturday, January 8th, 2011 AT 7:56 PM

GEARHEAD720

MEMBER
3 POSTS

When the oem slave cylinder was in its place the 90 degree banjo was at the bottom of the slave cylinder and the bleeder was on top easy accessable. The new slave cylinder Both banjo and Bleeder are on bottom.

Was this

answer

helpful?

Yes

No

Saturday, January 8th, 2011 AT 8:08 PM

SATURNTECH9

MECHANIC
30,870 POSTS

Those are all the one's I have seen also with the bleeder screw by the banjo. Here is the factory part number.
Slave Cylinder 04670065 $117.32
So does yours look like the top one in the diagram I posted or the bottom one?

Image (Click to make bigger)