WHAT IS CAUSING A MISFIRE AFTER REPLACING A BENT PUSHTUBE

1998 Chevrolet Truck

Tiny

joshua12880

September, 5, 2011 AT 6:06 PM

Water pump leak, replaced it then had misfire. Replaced plugs wires and cap and rotor. Found cyl #1 exh pushtube was bent, replaced it and still have misfire just not as bad. It starts ok, engine light blinks udner med accel @30-40mph. Oil is good coolant is good. Could the headgasket be blown or the intake collaspedand if so how to fix

FOUND 5708 RELATED QUESTIONS

Engine Miss

52 ANSWERS
12 IMAGES

1 Answer

Tiny

rasmataz

September, 5, 2011 AT 6:21 PM

Check engine light on
http://www.2carpros.com/articles/service-engine-soon-or-check-engine-light-on-or-flashing

Have the computer scanned for code/s-you have a problem within the engine management system that caused the CEL to turn on-This is your starting point of diagnosis,finding out what's going on.

Please login or register to post a reply.

Read Codes Like a Pro
How to gather codes Ford Explorer
Code Read Retrieval/Clear Mercedes-Benz C230