1998 CADILLAC CATERA
111,113 MILES
Avatar
BCMULLEN95
  • MEMBER
  • 249 POSTS
P0340 code just showed up. Could something other than the sensor cause the code to show up.
Nov 24, 2012 at 3:00 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
your cam sensor isn't reading right, it can be the sensor itself or connection or connection at pcm. it can also be a abad ecm but i think not, you can change it but teh code ahs to be serased then see if it goes on again. if it does take it to a proso they cna check it out further.
Nov 24, 2012 at 3:40 PM
Avatar
BCMULLEN95
  • MEMBER
  • 249 POSTS
I just replaced the EBTCM and was wondering if replacing that part I could have damaged the wiring to the camshaft position sensor.
Nov 24, 2012 at 3:55 PM
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
no it shouldn't it's probably just acam sensor gone bad,
Nov 24, 2012 at 5:22 PM
Avatar
BCMULLEN95
  • MEMBER
  • 249 POSTS
Exactly where can i locate this sensor?
Nov 25, 2012 at 8:26 PM
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
this is the drawing we have for it.
Image (Click to enlarge)
Attached Media
Nov 25, 2012 at 11:04 PM